1994-1996 Chevolet Caprice, Impala, Buick Roadmaster

The TDM (Theft Deterrent Module) is above and left of the brake pedal under the dash.

 

 

 

 

Option 1: Installation at TDM location

                               TDM Connector

 

 

Unplug the TDM and leave it unplugged, the PRO module replaces the TDM.

 

If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations): 

 

Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.

 

Set SW1 (8 switches) as following:

DIP SWITCHES (SW1)
1 2 3 4 5 6 7 8
off off on off on off on off

 

Leave SW2 (10 switches) the way it is. Close the PRO Module's cover.

 

To install the NEWROCKIES PRO Module, connect it as following (the TDM should be left unplugged as it is not needed anymore):

 

Pro Bypass

Car Wires

RED & WHITE wires   

Attach to the Pink  in pin A2

BLK

Attach to the Black with a White stripe in pin B5

PPL

Attach to the Yellow with a black stripe in pin A4

GRN

Attach to the Blue wire in A3

YEL

unconnected

WHT

unconnected

BRN

unconnected

 

 

IMPORTANT: If your car still does not start, please follow the troubleshooting directions for PASSKEY 1/2/3 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.

 

The installation is completed.

 
 

Option 2: Installation directly at ECM

This is to use in case your car is a project car and no TDM is installed.

 

If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations): 

 

Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.

 

Set SW1 (8 switches) as following:

DIP SWITCHES (SW1)
1 2 3 4 5 6 7 8
off off on off on off on off

 

Leave SW2 (10 switches) the way it is. Close the PRO Module's cover.

 

To install the NEWROCKIES PRO Module, connect it as following:

 

PRO Bypass       

Car Wires

RED

Splice to PCM Black connector B pin 30 PINK

BLK

Splice to PCM Red connector A Pin 2, Black with a White stripe.

PPL

Not used.

GRN

Attach to PCM Red connector A Pin 25, Dark Blue (make sure only the PRO Bypass is connected on this wire, so if the Dark Blue wire is present, cut it and connect the GRN (or BLU) of the PRO Bypass to it toward the ECM).

YEL

unconnected

BLU

unconnected

BRN

unconnected

 

 

IMPORTANT: If your car still does not start, please follow the troubleshooting directions for PASSKEY 1/2/3 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.

 

The installation is completed.

Have more questions? Submit a request

0 Comments

Article is closed for comments.