2007-2008 Pontiac Torrent, Chevrolet Equinox, 2008 Saturn Vue , 2007 - 11 GMC Acadia and Traverse

The factory security functions are managed by the Body Control Module (BCM) where we need to make the connections. The BCM is located behind the radio.

 

Starting at the bottom, pull to disengage the trim bezel clips.

Disconnect the electrical connectors from the center trim bezel

 

Remove the Radio.

 

 

We need connector C1  Light green 27 pins

 

 

and C3 light blue 25 pins.

 

Both show the end that goes into the BCM so be sure to count the opposite for looking at the back.

Make sure to cut 3-4 inches back from the BODY CONTROL MODULE.

 

If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations): 

 

Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.

 

Set SW1 (8 switches) as following:

DIP SWITCHES (SW1)
1 2 3 4 5 6 7 8
off off off on on off off on

 

Leave SW2 (10 switches) the way it is. Close the PRO Module's cover.

 

To install the NEWROCKIES PRO Module, connect it as following:

 

Pro Bypass      

Vehicle  Wires

RED

Splice into BROWN wire at the BCM Connector C1 Pin 21

BLK

Splice into BLACK with WHITE stripe wire at the BCM connector C3 Pin 1.

WHT

Splice into PINK wire at the BCM Connector C1 Pin 14

GRN

Unconnected

YEL

Splice into the WHITE wire at BCM connector C1 pin 2

BLU

unconnected

BRN

Cut WHITE with a BLACK stripe wire at the BCM connector C1 Pin 4 a couple inches from connector so you have room to connect the brown wire to the wire coming from the connector

 

 

Relearn Procedure

  1. Turn ON the ignition, with the engine OFF.
  2. Attempt to start the engine, then release the key to ON, vehicle will not start.
  3. Observe the SECURITY telltale. After approximately 10 minutes, the telltale will turn OFF.
  4. Turn OFF the ignition, and wait 5 seconds.
  5. Repeat steps 1 through 4 two more times for a total of 3 cycles/30 minutes. The vehicle is now ready to relearn the Passlock Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK.
  6. Important: The vehicle learns the password on the next ignition switch transition from OFF to CRANK. You must turn the ignition OFF before attempting to start the vehicle.
  7. Start the engine. The vehicle has now learned the password.

 

 

IMPORTANT: If your car still does not start, please follow the troubleshooting directions for Passlock 300 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.

 

The installation is completed.

Have more questions? Submit a request

0 Comments

Article is closed for comments.