2004-2012 Isuzu I-280,I290,I-350, Chevrolet Colorado, GMC Canyon Pickup, 2006-2010 Hummer H3

Locate the BCM as follows

 

Ensure the ignition switch is in the OFF position. Remove the right front hinge pillar trim panel

We need connector C1 and C2

 

These are both 64 pin pugs C1 is Black and C2 is GREY

 

If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations): 

 

Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.

 

Set SW1 (8 switches) as following:

DIP SWITCHES (SW1)
1 2 3 4 5 6 7 8
off off on on on off off on

 

Leave SW2 (10 switches) the way it is. Close the PRO Module's cover.

 

To install the NEWROCKIES PRO Module, connect it as following:

 

Pro Bypass        

Vehicle  Wires

RED

Splice into BROWN wire at the BCM Connector C2 Pin B7

BLK

Splice  black wire into BLACK with WHITE stripe wire at the BCM connector C1 Pin B3.

WHITE

Splice into the Dark Blue wire at BCM connector C2 Pin B8

GRN

Unconnected

YEL

Splice into the WHITE wire at BCM connector C2 pin A14

PPL

unconnected

BRN

 Cut WHITE with BLACK stripe wire at the BCM connector C2 Pin A42 a couple inches from connector so you have room to connect the brown wire to the wire coming from the connector

 

 

Relearn Procedure

  1. Turn ON the ignition, with the engine OFF.
  2. Attempt to start the engine, then release the key to ON, vehicle will not start.
  3. Observe the SECURITY telltale. After approximately 10 minutes, the telltale will turn OFF.
  4. Turn OFF the ignition, and wait 5 seconds.
  5. Repeat steps 1 through 4 two more times for a total of 3 cycles/30 minutes. The vehicle is now ready to relearn the Passlock Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK.
  6. Important: The vehicle learns the password on the next ignition switch transition from OFF to CRANK. You must turn the ignition OFF before attempting to start the vehicle.
  7. Start the engine. The vehicle has now learned the password.

 

IMPORTANT: If your car still does not start, please follow the troubleshooting directions for Passlock 300 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.

 

The installation is completed.

Have more questions? Submit a request

0 Comments

Article is closed for comments.