2001 Oldsmobile Aurora

How to reach the Theft Deterrent Control (TDM) module’s plug

 

To get to the TDM module you will need to remove the instrument cluster trim panel,  the TDM is located behind the information center number 3 in the picture below. You will be connecting the PRO Bypass module on the TDM plug (number 4 in the picture).

 

 

Remove the Instrument Panel Trim Plate Bezel to reach the TDM.

 

TDM Connector

 

If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations): 

 

Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.

 

Set SW1 (8 switches) as following:

DIP SWITCHES (SW1)
1 2 3 4 5 6 7 8
on off off off off on on off

 

Set SW2 (10 switches) as following:

DIP SWITCHES (SW2)
1 2 3 4 5 6 7 8 9 10
off off off off off off off on off off

 

To install the NEWROCKIES PRO Module, connect it as following:

 

PRO Bypass

Car Wires

RED & WHITE wires 

Splice to the WHT wire on TDM plug terminal F

BLK

Splice to the BLK/WHT wire on TDM plug terminal H

PPL

Not Used

GRN

Not Used

YEL

Cut the Yellow wire on terminal B and connect the YEL from the Pro-Bypass to the it toward the plug and tape the other side as it will not be used.

BLU

Not Used

BRN

Splice to the BLK wire on TDM plug terminal J.

 

Preform the following relearn process

 

1) With a master passkey III key (Black), turn ON the ignition, with the engine OFF.

2) Observe the Security telltale, after approximately 10 minutes the telltale will turn off.

3) Turn OFF the ignition, and wait 5 seconds.

4) Repeat steps 1-3 two more times for a total of 3 cycles or 30 minutes.

On the next time the key is turned to start the car will start.

 

 

IMPORTANT: If your car still does not start, please follow the troubleshooting directions for Passlock 1/2 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.

 

The installation is completed.

Have more questions? Submit a request

0 Comments

Article is closed for comments.