2000-2003 Chevrolet Safari and Astro

Locate the BCM and install the PRO Bypass Module

The BCM is behind and above the radio.

Remove the radio and the heater control out to gain access to the Body Control Module.

 

 

 

There are 3 electrical connectors on the BCM (C1, C2, C3). We will only need to work on C1 and C2.

 

Safari BCM C1, 24 pin Brown

 

Safari BCM C2, 24 pin Light Blue

 

If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations): 

 

Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.

 

Set SW1 (8 switches) as following:

DIP SWITCHES (SW1)
1 2 3 4 5 6 7 8
on off off off off on on off

 

Set SW2 (10 switches) as following:

DIP SWITCHES (SW2)
1 2 3 4 5 6 7 8 9 10
off off off off off off off on off off

 

To install the NEWROCKIES PRO Module, connect it as following:

Pro Bypass

Car Wires

RED & WHT wires    

Splice into the PINK wire in BCM connector C1, pin B2

BLK

Splice iinto the Black wire in BCM connector C1, Pin A1

PPL

Unconnected

GRN

Unconnected

YEL

Cut the Yellow wire on BCM connector C2 Pin B3 and connect the YEL from the PRO module to it toward the BCM.

BRN

Splice into the orange/black wire in BCM connector C2, Pin A2

 

 

The above picture that has red wire also needs the white connected

 

Perform the re-learning procedure

  1. Turn ON the ignition, with the engine OFF.
  2. Attempt to start the engine, then release the key to ON (vehicle will not start).
  3. Observe the SECURITY light, after approximately 11 minutes the light will turn OFF.
  4. Turn OFF the ignition, and wait 10 seconds.
  5. Repeat steps 1 through 4 two more times for a total of 3 cycles/30 minutes ( the vehicle is now ready to relearn the Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK).

 

Important: The vehicle relearns Sensor Data Code and/or password on the next ignition switch transition from OFF to CRANK. You must turn the ignition OFF before attempting to start the vehicle.

Start the engine (the vehicle has now learned the Sensor Data Code and/or password).

 

 

IMPORTANT: If your car still does not start, please follow the troubleshooting directions for Passlock 1/2 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.

 

The installation is completed.

Have more questions? Submit a request

0 Comments

Article is closed for comments.