1998-1999 Oldsmobile Intrigue

Locate the BCM and install the PRO Bypass module.

 

The BCM is is under the left side of the dash. Remove the 3 retainers and remove the hush panel or it is also called the sound insulator.

 

 

 

Then unplug the BCM which is #5 in the picture above.

 

There are 3 electrical connectors on the BCM (C1, C2, and C3) as following:

 

The 32 pin pink connector (C1).

The C2, Pink

 

And the White Connector C3

 

If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations): 

 

Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.

 

Set SW1 (8 switches) as following:

DIP SWITCHES (SW1)
1 2 3 4 5 6 7 8
on off off off off on on off

 

Set SW2 (10 switches) as following:

DIP SWITCHES (SW2)
1 2 3 4 5 6 7 8 9 10
off off off off off off off on off off

 

To install the NEWROCKIES PRO Module, connect it as following:

 

PRO Bypass

Car Wires

RED & WHITE wires       

Splice in to the WHITE wire going into the BCM connector C2 Pin A6

BLK

Splice into the BLACK wire going into the BCM Connector C3 Pin D

PPL

Not Used

GRN

Not Used

YEL

Cut the Yellow wire on BCM connector C1, Pin D2. Tape the side that goes toward the car and connect the YEL wire of the PRO module to the other side going into the BCM connector.

BLU

Not Used

BRN

Slice into the BLACK wire going into BCM Connector C1, Pin D3

 

 

 

Perform the re-learning procedure

  1. Turn ON the ignition, with the engine OFF.
  2. Attempt to start the engine, then release the key to ON (vehicle will not start).
  3. Observe the SECURITY light, after approximately 11 minutes the light will turn OFF.
  4. Turn OFF the ignition, and wait 10 seconds.
  5. Repeat steps 1 through 4 two more times for a total of 3 cycles/30 minutes ( the vehicle
  6. is now ready to relearn the Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK).

 

Start the engine (the vehicle has now learned the Sensor Data Code and/or password).

 

IMPORTANT: If your car still does not start, please follow the troubleshooting directions for Passlock 1/2 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.

 

The installation is completed.

Have more questions? Submit a request

0 Comments

Article is closed for comments.