1997 Oldsmobile Silhouette

The Theft module is intergral to the Body Control Module so we need to splice into the Body Control Module connectors.

The Body Control Module is under the dash, far right.

 

 

Connector C1

 

Connector C2

 

 

If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations): 

 

Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.

 

Set SW1 (8 switches) as following:

DIP SWITCHES (SW1)
1 2 3 4 5 6 7 8
off off on off on off on off

 

Leave SW2 (10 switches) the way it is. Close the PRO Module's cover.

 

To install the NEWROCKIES PRO Module, connect it as following (the TDM should be left unplugged as it is not needed anymore):

 

PRO Bypass Car Wires

RED         

Splice to  the PINK wire on Body Control Module connector C2 Pin D13

BLK

Splice to the black wire on Body Control Module Connector C1 Pin D

PPL

unconnected

GRN

Cut the dark blue wire on Body Control Module Connector C2 Pin C16

YEL

unconnected

WHT

unconnected

BRN

unconnected

 

Do NOT plug back the original TDM. The PRO Full Bypass replaces the TDM.

 

 

IMPORTANT: If your car still does not start, please follow the troubleshooting directions for PASSKEY 1/2/3 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.

 

The installation is completed.

Have more questions? Submit a request

0 Comments

Article is closed for comments.