1997-1999 Pontiac Grand Prix

The connections to be made on the Grand Prix are at the Body Control Module. The Body Control Module is under the dash, left side by the parking brake pedal.

 

Remove the left instrument panel insulator. Refer to Instrument Panel Insulator.

Disconnect the BCM electrical connectors.

There are only 2 connectors. First is the nature or white C1 with 8 terminals.

And second is the Blue C2 connector with 32 terminals.

These pictures are looking into the end of the plug that goes into the module.

 

If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations): 

 

Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.

 

Set SW1 (8 switches) as following:

DIP SWITCHES (SW1)
1 2 3 4 5 6 7 8
off off on off on off on off

 

Leave SW2 (10 switches) the way it is. Close the PRO Module's cover.

 

To install the NEWROCKIES PRO Module, connect it as following:

 

-Cut the Dark Blue wire on Connector C2, pin D16. Tape the side that goes to the BCM.

 

Pro Bypass       

Car Wires

RED

splice into the pink wire in connector C2, pin C13.

BLK

splice into the black wire in connector C1, Pin D.

PPL

Unconnected

GRN

connect to the Dark Blue wire in Connector C2, Pin D16 toward the harness away from the BCM

YEL

Unconnected

WHT

Unconnected

BRN

Unconnected

 

 

 

 

 

IMPORTANT: If your car still does not start, please follow the troubleshooting directions for PASSKEY 1/2/3 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.

 

The installation is completed.

Have more questions? Submit a request

0 Comments

Article is closed for comments.