1998-1999 Chevrolet Monte Carlo, 1998-2001 Lumina

How to reach the TDM and install the PRO Full Bypass

Remove the right side instrument panel insulator.

Remove the instrument panel compartment.

Remove the theft deterrent module (TDM) bracket mounting bolts (2).

Remove the theft deterrent module bracket from the cross car beam (4).

Remove the theft deterrent module mounting bolts from the bracket (3).

Remove the theft deterrent module from the bracket.

Disconnect the electrical connector from the module.

 

 

The TDM Connector is as following:

 

Unplug the TDM and leave it unplugged, the PRO module replaces the TDM.

 

If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations): 

 

Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.

 

Set SW1 (8 switches) as following:

DIP SWITCHES (SW1)
1 2 3 4 5 6 7 8
off off on off on off on off

 

Leave SW2 (10 switches) the way it is. Close the PRO Module's cover.

 

To install the NEWROCKIES PRO Module, connect it as following (the TDM should be left unplugged as it is not needed anymore):

 

PRO Bypass       

TDM Connector Plug

RED

TDM pin A2 (PNK)

BLK

TDM pin B5 (BLK)

PPL

TDM pin A4 (YEL/BLK) or ( BLK/YEL)

GRN

TDM pin A3 (DK BLUE)

YEL

unconnected

WHT

unconnected

BRN

unconnected

 

 

IMPORTANT: If your car still does not start, please follow the troubleshooting directions for PASSKEY 1/2/3 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.

 

The installation is completed.

Have more questions? Submit a request

0 Comments

Article is closed for comments.