1993 Cadillac 60 Special

The Theft Deterrent Module, Passkey Decoder Module  or TDM/PDM  is under the dash, right side.

 

-Remove the glove box, Disconnect the wiring from the retainer, Remove the Relay center

-Remove the 3 screws from the relay bracket, Remove the relay center bracket.

-Remove the 2 Module screws, Disconnect the electrical connector and remove the module.

 

 

 

 

 

Unplug and remove the Passkey decoder module. The PRO Full Bypass replaces the PDM.

 

If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations): 

 

Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.

 

Set SW1 (8 switches) as following:

DIP SWITCHES (SW1)
1 2 3 4 5 6 7 8
off off on off on off on off

 

Leave SW2 (10 switches) the way it is. Close the PRO Module's cover.

 

To install the NEWROCKIES PRO Module, connect it as following (the PDM should be left unplugged as it is not needed anymore):

 

PRO Bypass       

Car Wires

RED

Attach to the PNK or PNK/BLK or PPL/WHT at the PDM Connector Pin A2

BLK

Attach to the BLACK with a WHITE stripe at the PDM connector Pin B5

PPL

Attach to the  (YEL/BLK or BLK/YEL) at the PDM connector Pin A4

GRN

Attach to the DARK BLUE wire at the TDM connector Pin A3

YEL

Not used.

WHT

Not Used

BRN

Not used

 

 

IMPORTANT: If your car still does not start, please follow the troubleshooting directions for PASSKEY 1/2/3 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.

 

The installation is completed.

Have more questions? Submit a request

0 Comments

Article is closed for comments.