1993, 1994 Cadillac Fleetwood

How to reach the TDM and install the PRO Full Bypass

 

The TDM is a function of the CCM module that is located under the rear shelf in the trunk.

 

 

The CCM has 2 connectors: C1 and C2

 

If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations): 

 

Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.

 

Set SW1 (8 switches) as following:

DIP SWITCHES (SW1)
1 2 3 4 5 6 7 8
off off on off on off on off

 

Leave SW2 (10 switches) the way it is. Close the PRO Module's cover.

 

To install the NEWROCKIES PRO Module, connect it as following:

 

Pro Bypass       

Car Wires

RED

Splice into the PINK or PINK BLACK wire at the  CCM Connector C1, pin B9

BLK

Splice into the BLACK or BLACK  with a WHITE stripe  at the CCM Connector C2 pin C1

PPL

cut the Yellow wire with a black or black with a yellow stripe at the CCM Connector C2, pin D13 and attach the PPL wire of the PRO module to it on the vehicle side, not toward the CCM connector. Tape the other side

GRN

cut the Dark Blue wire on CCM Connector C1 pin B1  and attach the GRN wire of the PRO module to it on the vehicle side, not toward the CCM connector. Tape the other side.

YEL

Unconnected

WHT

unconnected

BRN

Unconnected

 

 

IMPORTANT: If your car still does not start, please follow the troubleshooting directions for PASSKEY 1/2/3 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.

 

The installation is completed.

Have more questions? Submit a request

0 Comments

Article is closed for comments.