1990-1992 Cadillac Fleetwood FWD

How to reach the Passkey Decoder Module (PDM) and install the PRO Full Bypass

 

The PDM is behind the right side of the dash a the Right side shroud behind the relay center.

 

 

 

The PDM Connector is as following:

 

Unplug the Passkey decoder module and leave it unplugged, the PRO module replaces it.

 

If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations): 

 

Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.

 

Set SW1 (8 switches) as following:

DIP SWITCHES (SW1)
1 2 3 4 5 6 7 8
off off on off on off off on

 

Leave SW2 (10 switches) the way it is. Close the PRO Module's cover.

 

To install the NEWROCKIES PRO Module, connect it as following (the TDM should be left unplugged as it is not needed anymore):

 

 

PRO Bypass        

Car Wires

RED

Attach to the PDM Connector pin A1 (PNK or PPL/WHT)

BLK

Attach to the PDM Connector Pin B1 (BLK or BLK/WHT)

PPL

Attach to the PDM Connector pin A3 (YEL/BLK or BLK/YEL)

GRN

Attach to the PDM Connector  pin A2 (DK BLUE)

YEL

unconnected

BLU

unconnected

BRN

unconnected

 

 

IMPORTANT: If your car still does not start, please follow the troubleshooting directions for PASSKEY 1/2/3 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.

 

The installation is completed.

Have more questions? Submit a request

0 Comments

Article is closed for comments.